Solder Pena Gas Solder Portable Pencil Torch Las Kecil Pencil Butane

Solder Pena Gas Solder Portable Pencil Torch Las Kecil Pencil Butane

Dikiirim dalam keadaan GAS KOSONG

A lighter is needed for ignition, the soldering iron itself cannot be ignited

ignite:

1. Turn the gas source switch, you can hear the gas flow moving to the sounds and smells little gas.

2. At this igniter can be aligned iron head ignition opening portion, and then to observe the opening of the tip portion points which will turn red. Ready to use,

   The soldering iron valve adjusts the size of the valve to control the temperature of the soldering iron tip . When adjusting the temperature, it can also be judged by observing the brightness of the opening of the soldering iron tip

   The temperature is high and low. When the valve is closed, there is a certain delay, and the flame will not be extinguished immediately.

3. Be careful not to adjust too much at once, otherwise it will be very dangerous.

4. There is a small hole at the bottom of the soldering iron for refilling, which is the same as our lighter refilling when used .

Fill gas:

1. The switch is in the OFF position, and a high-quality gas canister is used

2. Introduce the gas tank into the air hole and press down to inflate

3. After finishing, wait a few minutes, wait for the gas to stabilize before using

4. If the gas is filled in, there is a hissing sound in the tail, and it can be eliminated by pressing it into the air port with a pen tip.

Special attention: the heated soldering iron should not be placed directly on the table, plastic products, etc., to avoid scalding the object, and be careful not to touch it with your hands to avoid danger.

If there are children nearby, you should pay more attention. After use, store it after cooling down.

 Can be used as a spray gun: unscrew the soldering iron tip, open the air valve, and ignite with a lighter, then it can be used as a spray gun. It is very useful for outdoor ignition and welding of plastic products.

parameter:

Packing: card packing (237*70*31mm)

Weight: about 86g

Temperature: Soldering iron tip: 210～400℃ (equivalent to 70-100W soldering iron) Flame: 1300℃ (2500℉)

Capacity: about 7 ml

Operating time: 30 minutes (intermediate setting)