LCD 12864 12864-06D DOT Matrix COG Screen Moudule SPI ST7565 Biru

LCD 12864 12864-06D DOT Matrix COG Screen Moudule SPI ST7565 Biru

Product Information:

Name: LCD module
LCD Mode: FSTN / Transflective Positive Mode
Model: GMG12864-06D
Resolution: 128*64
Dimensions: 61.8*45.8*6.8(mm)
Display size: 48.6*24.28(mm)
Driver IC: ST7565R
Viewing direction: 60'clock
Working temperature: -20°C + 70°C
Storage temperature: -30°C + 80°C
Voltage: 3.3 V
Interface mode: SPI Interface

menggunakan library U8g2,

UNCOMMENT > U8G2_ST7565_ERC12864_F_4W_SW_SPI u8g2(U8G2_R0, /* clock=*/ 13, /* data=*/ 11, /* cs=*/ 10, /* dc=*/ 9, /* reset=*/ 8);

LCD   -   MCU

CS     -   CS / 10
RSE   -   RESET / 8
RS     -   DC / 9
SCL   -   CLOCK / 13
SI      -   DATA / 11
VDD  -   3.3V
VSS   -   GND (seri dengan VR 10K untuk adj. kontras karakter)
A       -   ANODA BACKLIGHT (seri dengan res. 100ohm jika mau agak redup)
K       -   KATODA BACKLIGHT

PIN LIBRARY DAPAT DIUBAH DAN DISESUAIKAN DENGAN PIN YANG MAU DIPAKAI

.

.

.

contoh program

#include <Arduino.h>
#include <U8g2lib.h>

#ifdef U8X8_HAVE_HW_SPI
#include <SPI.h>
#endif
#ifdef U8X8_HAVE_HW_I2C
#include <Wire.h>
#endif

U8G2_ST7565_ERC12864_F_4W_SW_SPI u8g2(U8G2_R0, /* clock=*/ 13, /* data=*/ 11, /* cs=*/ 10, /* dc=*/ 9, /* reset=*/ 8);

void setup(void) {
u8g2.begin();
}

void loop(void) {

u8g2.clearBuffer(); // clear the internal memory
u8g2.enableUTF8Print();
u8g2.setFont(u8g2_font_6x13B_t_cyrillic);
u8g2.setCursor(4, 22);
u8g2.setContrast (80);
u8g2.print("JOGJAROBOTIKA");
u8g2.setFont(u8g2_font_cu12_t_cyrillic);
u8g2.setCursor(4, 42);
u8g2.print("Теxт 123 test");
// write something to the internal memory
u8g2.sendBuffer(); // transfer internal memory to the display
delay(1000);
}

Forum